There are two types of stainless steel rope net. The shape of the mesh is diamond or approximate square. For the mesh of stainless steel rope mesh, the shape of the mesh can be changed. So the shape of the mesh can be adjusted according to your requirements. However, changes in the shape of the mesh change the performance, size and aesthetics of the stainless steel rope mesh.

Firstly, the stainless steel rope mesh is made up of many small meshes. Changing the mesh of the stainless steel rope mesh is mean that changes the length and width of the stainless steel rope mesh. Therefore, you need to determine the size of the mesh to determine the overall size of the stainless steel rope mesh. This is the most important.
For ferrule type stainless steel rope mesh, you can stretch the mesh to approximately 90 degrees, but the mesh is unlikely to reach 90 degrees. The ferrule limits the angle of the mesh. We also don’t recommend that the mesh be close to 90 degrees. If you do this, the ferrule will be subjected to a lot of tension and the frame will be subjected to a lot of tension. Very important, this is not beautiful. In the next paragraph we explain the aesthetics.
Under normal conditions, the mesh angle of the ferrule stainless steel rope net is 60 degrees, and the angle of the knotted stainless steel mesh is 90 degrees. Below we give you a few photos for reference.

For the size, in the case of the quadrilateral, the area of the square is the largest in the case of the same side length. This means that the larger the angle, the greater the cost, the larger the area you get.
For woven type stainless steel rope net, it is generally used in zoos. The 90 degree angle not only saves cost, but also looks good, and the large mesh also increases visibility.
The size of the mesh is derived from our experience. If you have any questions or suggestions, please leave a message.